• Outer diameter is nominal. This means the outer diameter is machined for the least stock removal until the surface is:
1. Free of all defects
2. Surface finish of 32 micro inches (Ra). This prevents any scratching of delicate webs - films, etc.
3. The outer diameter and bore are concentric within 0.002"
4. Straight within 0.002" or 0.0005" per foot of length. Includes: 1. Two low friction ball bearings. One pressed into each end.
a. Each bearing includes 2 socket head set screws to lock the inner ring of the bearing to the dead (non-rotating) mounting shaft (sold separately) Note: Worn bearings may be replaced using a bearing puller for removal. Replacement bearings are sold separately.
| Support | |
| Phone and email Support | |
| Warranty | |
| Condition | |
| Product Condition | |
Dead Shaft Idler Roll with Straight Face including Mounting shaft
-
Categories:
- Choose your options
- Part #: Choose Options and Click Add to Cart
- Availability: Ships in 8 - 10 weeks from our factory in Fairfield, NJ USA
-
$0.00 Each